just picked up a half built DIYPNP
6 Attachment(s)
so here is the DIYPNP i picked up for 50 bucks....
here are some pics, yall tell me what yall think Attachment 198369 Attachment 198370 Attachment 198371 the solder broke on this wire so i gotta figure out where it goes and finish this thing up. Attachment 198372 this is apparently a MSII daughter board, i gotta figure out where the fuck this thing goes. Attachment 198373 Attachment 198374 im going to start doing some research on this and read all i can on how to build this damn thing, so wish me luck and hopefully i wont fuck this up :giggle: |
I'll give ya $75 for it...
|
Looks like quite a challenge there...
The MS2 daughterboard goes in place of the large black IC that's sitting in the U1 position. Be sure to read the "converting from MS1 to MS2" documentation. |
Originally Posted by gospeed81
(Post 557836)
I'll give ya $75 for it...
Originally Posted by Joe Perez
(Post 557837)
Looks like quite a challenge there...
The MS2 daughterboard goes in place of the large black IC that's sitting in the U1 position. Be sure to read the "converting from MS1 to MS2" documentation. |
Photos of bare electronic components on shag carpeting freak me out :giggle:
|
haha! none of the components touched the carpet.....i made sure. lol
|
Just for the record... This is not a DIYPNP it's a standard MS1/2 v.3.0 with a plug and play harness. Re-check everything that has been done to the board - check the harness if the pinout fit's your car.
Greets |
Originally Posted by WonTon
(Post 557831)
so wish me luck and hopefully i wont fuck this up :giggle:
Good luck with the conversion. |
Originally Posted by Zaphod
(Post 557965)
Just for the record... This is not a DIYPNP it's a standard MS1/2 v.3.0 with a plug and play harness. Re-check everything that has been done to the board - check the harness if the pinout fit's your car.
Greets
Originally Posted by turotufas
(Post 557967)
I know I fucked mines up. :facepalm:
Good luck with the conversion. how bad did you fuck yours up? |
1 Attachment(s)
Originally Posted by WonTon
(Post 558004)
thanks man...
how bad did you fuck yours up? I burned some hard to get to traces. By the time I figured out what happened I was too pissed to continue. I thought about slamming it on the ground. After I got my new one and cooled off I fixed the traces and I rewired my mistake. https://www.miataturbo.net/attachmen...4&d=1271611471 |
All times are GMT -4. The time now is 03:59 PM. |
© 2024 MH Sub I, LLC dba Internet Brands