Launch control on 92 DIYPNP
 

Hey all, I am trying to wire up launch control/ flat foot shift on a 92’ DIYPNP. From my understanding and research, all you have to do is wire pin 1V to the input2 input, then input2 output to FLEX. Clearly this is not all you have to do, because it is still not working. Do you have to put another wire from FLEX to a pin on the DB15 connector, then from there to the clutch switch? Sorry for my lack of electrical knowledge, I appreciate all the help!

Are you running a MS3 diy pnp pro?

It's a MS2 PNP, I got from DIYAuto Tune. It has the v1.5 main board.

Are you running the MS2 PNP or the DIYPNP?

It’s the DIYPNP. Sorry for the confusion

That should be all you need to do, other than setting up FLEX for lunch control. I would suggest using a multimeter and make sure there's continuity from 1V (on the harness side) to ground when the clutch is in and there is not continuity when the clutch is out. Some years you have to disconnect the neutral switch from the trans.

Okay I’ll try that. I tried disconnecting the neutral switch already, but that didn’t change anything. Thanks for the help.