MAF delete error issues
09-29-2007, 05:55 PM
#1
Junior Member
Thread Starter
iTrader: (1)
Join Date: May 2006
Location: Athens, GA
Posts: 247
Total Cats: 0
MAF delete error issues
I'm trying to delete the MAF now. I copied the src folder over to the with out MAF folder like I saw in another thread here. when I use the download firmware file, that all loads up fine (or appears to).
After that, I open megatune and try to open the msq file that I was using up to today. When I open it says there are six warnings, if I hit 'yes' to the send to unit it says "page 1 could not connect to controller" and goes through that for several pages.
Out of curiosity, I went back and reloaded the with afm stuff and opened the msq in megatune. It loaded fine. WTF?!
any ideas? I have a buddy over here helping and we can't seem to figure it out.
After that, I open megatune and try to open the msq file that I was using up to today. When I open it says there are six warnings, if I hit 'yes' to the send to unit it says "page 1 could not connect to controller" and goes through that for several pages.
Out of curiosity, I went back and reloaded the with afm stuff and opened the msq in megatune. It loaded fine. WTF?!
any ideas? I have a buddy over here helping and we can't seem to figure it out.
Last edited by GTS Miata; 09-29-2007 at 10:41 PM.
Reply
0
0
09-29-2007, 10:39 PM
#4
Junior Member
Thread Starter
iTrader: (1)
Join Date: May 2006
Location: Athens, GA
Posts: 247
Total Cats: 0
The car is running pretty well, but it is rich, in the 12's at idle. Since I'm still normally asp. I guess I need to dial the fuel back.
This is weird because it is the same msq that I was running before I removed the MAF. It wasn't running rich when the MAF was in earlier today...
This is weird because it is the same msq that I was running before I removed the MAF. It wasn't running rich when the MAF was in earlier today...
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM
