chucker

iTrader: (4)

I built a MSI V3.0 and passed all tests up to and including step 55.
Controlled Megatune gages with Stim pots.
Finished building board to the end.
Washed board with acetone and re-inspected all joints. Everything was spick and span.

Woke up this morning and hooked MS to DB9 cable and Stim and I get nothing. Fresh battery. Nothing. Double checked my cable, jumped pins 2&3 and got echo. Plugged cable back into MS, jumped U1 pins 12 & 13, no echo. If I jump DB9 pins 2 & 3 on the board, I get appropriate echo so I know DB9 cable is connected to MS.


Stuck at test in step 26.g.

Pin 4 of processor shows 32.76hz
Testing on the MAX232 shows
Pin 16 is 4.95
Pin 15 = 0.6 Ω to the middle pin of U5
Pin 11 to CPU Pin12 = ~0.3 Ω
Pin 12 to CPU pin 13 ~0.3 Ω
Power supply testing on U1 pins all succesful.
I have 5 volts between pins 19 (ground) and 20 (+5), there is also +5 on pin 1 and 31 (checked against ground at pin 19), and there is ground potential on pins 2 and 32 (checked against +5V on pin 20). The processor has power on the 40-pin socket but none of the LEDs on the MS respond. Capacitors with polarity and all diodes were triple checked for correct orientation and all checks out.

As I stated before, everything passed testing up to and including step 55. Then I brushed off the flux with acetone, gently blew it off with compressed air and waited approx. 12 hours. Hooked back up and now I don’t get response.

I’ve spent several hours searching and troubleshooting and I’d greatly appreciate any assistance.

Thanks

cjernigan

iTrader: (13)

I've damaged a processor before so if everything else checks out don't rule out a dead processor as a possibility. Anyone near you have an MS so you can try out their chip?