Looking for MS1 v2.2 modding diagrams
Hi Everyone,
I've been looking for a diagram on how to mod the typical MS1 v2.2 board for use in the Miata, however I keep coming up with v3 boards. Can anyone point me in the right direction? THanks Scott |
|
Thanks, can anyone explain to me a bit more about the 420a neon setup?
|
This would be the outputs for a 2.2: MSnS Extra Ignition Hardware Manual
|
http://boostedmiata.com/MS/v2board.JPG
excuse my shitty diagram. Use 100-300ohm resistors for the spark pull up. For the tach input:470ohm resistor between the front of D9 to the back of D5. second trigger: 470phm resistor from the spot between r13 and d9 to wherever the tach input is coming in from, then a 1K resistor to pin 11 on the CPU. I belive that's all you need, make sure you position the transistors correctly on q3-5-9-10-11. |
Thank you sir, exactly what I was looking for!!!
|
All times are GMT -4. The time now is 03:20 AM. |
© 2024 MH Sub I, LLC dba Internet Brands