Megalog Viewer Scaling
 

Watching playback of my datalogs in MLV and I have a small issue. The AFR Target line is pegged at the top of the graph, and almost never changes unless my AFR dips below 13.0. At 14.7, it's perfectly in line with the very top of the graph. The Actual AFR is right in the center, bouncing around like I would expect. The lines used to overlay, but now they don't even though the actual and target are almost dead on. Is this a setting in MLV that can be changed?

yes.

Good, I hoped it was something simple, I was worried that it wasn't picking up a signal from the WB. I did check through the menus in MLV and did not find anything that stands out. I set the Wideband to custom linear like I have in TS, but that didn't change anything.

min max value; make both the AFR and AFR Targets read 10 - 20:1

Odd, I scaled it like you said and it worked fine, but when returned to autoscale, it goes back to the upper limits. Shouldn't autoscale remedy that?

Edit: Nevermind, autoscaling works fine. My AFR Target table had 14.7 as the highest target.