MegaSquirt Idle - - Throttle body inlet hose
Can I remove this hose, and plug the throttle body inlet or put a filter on there?
I would like to use an intake set up that does not have accommodations for that hose. |
No pic/diagram... did you mean to post one?
If you're talking about the 1/4" or so hose that runs up to the 6 o'clock position in front of the throttle body, I'm pretty sure it's needed for the IAC. I ended up putting an adapter in my elbow there to keep it. You should be able to do the same. Check out Alec Moody's website for details? 3D printed intake |
Think it's more like 1/2", but yeah it's for the IAC, it won't idle without it. You can leave it with a filter, I've done that before with good results.
|
plugging the inlet to your idle valve sounds smart.
|
As anyone noticed better idle with the filter vs plumbing IACV to the intercooler cold side. I'd imagine it wouldn't matter.
|
The only difference with putting a filter on is that it will become a slight boost leak. Doesn't matter at all for a normally aspirated car.
|
You could install a one-way check valve to prevent boost loss in the hose.
|
I had this same problem im boosted so i would lose boost and consequently spool the pipe is actually 3/4 inch i bought a 3/4 inch slip on aluminum bung and used alumaweld (harbor frieght) to braze it on to the cold side intercooler piping with a map gas torch works great idle is very stable spool improved
|
All times are GMT -4. The time now is 12:08 PM. |
© 2024 MH Sub I, LLC dba Internet Brands