Megasquirt, LC1 and Innovative Pod Gauge Question
 

Ok this is a simple one but I want to double check.

The Signal for WB02 for MS is Output 2 0v-5v which is the brown wire on the LC1.
This is the wire I need to connect to my MS2 Unit.

However the Gauge Pod says it wants the Brown Wire for signal as well and I don't know how comfortable I feel about connecting both of them to the same wire....

There is the Yellow Wire for Narrow Band output is open obviously. So I have two options and I wanted to see what others had done:

1) Connect the Gauge and MS to the Brown Wire together

2) Using the Software and serial connector, program the yellow output to 0v-5v as well and connect that to the Gauge.

Thanks for the help.

I'm at work right now, but I'll be home around midnight EST. I have a picture of how to hook it up and set it, I'll get ya up to spec when I get home.

I got it I made the yellow a WB output as well. Having more problems going to the other thread.

Yep, as you've already done. Just program the simulated NB output (yellow wire) to whatever you like in LM programmer.

I've got my Brown wideband outputting 0-5v over AFRs of 10-20:1. I've also got my 2nd output (yellow wire) programmed to output 10-18:1 and hooked that up to my LED AFR gauge. It's actually very easy to read as you're looking at LEDs and not reading a figure as such. Plus the uppermost LED is 14.7:1, making stoich easy to spot.