URGENT Need help, no RPM input!
#1
Elite Member
Thread Starter
iTrader: (12)
Join Date: Jan 2007
Location: Hermosa Beach, CA
Posts: 2,573
Total Cats: 12
URGENT Need help, no RPM input!
Ok so my car has been running fine for a while. Today I went to start it and it dident even catch.
It seems then when I crank it over, megatune shows a random rpm for .5 of a sec, then it shows 0 rpm.
For example, When I crank the car over, megatune will show 330 rpm and a PW of 3.2 for half of a seconded, then it shows 0 rpm and the resulting 0 PW.
Also, I have COPS.
I know the wireing from the bord to the harness is fine, I checked.
Its weird its like MS senses the RPM for a half a sec, then doesent.
What the hell is going on!? and I need the car to drive to the beach tommorow haha.... ****.
Is there something I can check with the cops?
ALSO IT RUNS FINE WITH THE STOCK ECU AND AFM (altho rich from my large injectors, but it runs none the less)
It seems then when I crank it over, megatune shows a random rpm for .5 of a sec, then it shows 0 rpm.
For example, When I crank the car over, megatune will show 330 rpm and a PW of 3.2 for half of a seconded, then it shows 0 rpm and the resulting 0 PW.
Also, I have COPS.
I know the wireing from the bord to the harness is fine, I checked.
Its weird its like MS senses the RPM for a half a sec, then doesent.
What the hell is going on!? and I need the car to drive to the beach tommorow haha.... ****.
Is there something I can check with the cops?
ALSO IT RUNS FINE WITH THE STOCK ECU AND AFM (altho rich from my large injectors, but it runs none the less)
#4
Elite Member
Thread Starter
iTrader: (12)
Join Date: Jan 2007
Location: Hermosa Beach, CA
Posts: 2,573
Total Cats: 12
Well I got it running... for some reason one of the wired imbedded into the MS bord was scratched and broken. I put some solder on it, seems to work.
But now the Tach in the car doesent move? lol this I do not understand. The tach gets its signal from the gray sheilded wire from the MS, correct?
But now the Tach in the car doesent move? lol this I do not understand. The tach gets its signal from the gray sheilded wire from the MS, correct?
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM
JesseTheNoob
DIY Turbo Discussion
15
09-30-2015 02:44 PM
Motorsport-Electronics
ECUs and Tuning
0
09-05-2015 08:02 AM