troulbleshoot TS connection issue
#1
troulbleshoot TS connection issue
New to MS. I have a MS-3 that has been previously tuned by an outside professional. I would like to datalog a track session, however I can't seem to obtain a connection of the MS-3 to tuner studio.
This seems pretty straight forward. I have purchased the upgraded version of TS. I'm using a printer cable (square end///USB) to connect. I plug everything together; Start up TS; start car. The prompt says not connected.
I've tested the printer cable. It works fine for a printer.
Q: Do I need some sort of update to TS? Q: Do I need to use a different lead? Q: Is there some "captain obvious" solution that I've missed?
This seems pretty straight forward. I have purchased the upgraded version of TS. I'm using a printer cable (square end///USB) to connect. I plug everything together; Start up TS; start car. The prompt says not connected.
I've tested the printer cable. It works fine for a printer.
Q: Do I need some sort of update to TS? Q: Do I need to use a different lead? Q: Is there some "captain obvious" solution that I've missed?
#2
SADFab Destructive Testing Engineer
iTrader: (5)
Join Date: Apr 2014
Location: Beaverton, USA
Posts: 18,642
Total Cats: 1,866
What kind of computer.
If windows install this:
Virtual COM Port Drivers
Do you have the vehicle project and stuff open on your computer already? Or new project.
Post a picture of the communication settings.
Communications menu->settings.
If windows install this:
Virtual COM Port Drivers
Do you have the vehicle project and stuff open on your computer already? Or new project.
Post a picture of the communication settings.
Communications menu->settings.
#3
What kind of computer.
If windows install this:
Virtual COM Port Drivers
Do you have the vehicle project and stuff open on your computer already? Or new project.
Post a picture of the communication settings.
Communications menu->settings.
If windows install this:
Virtual COM Port Drivers
Do you have the vehicle project and stuff open on your computer already? Or new project.
Post a picture of the communication settings.
Communications menu->settings.