cpolly69

iTrader: (2)

Trying to get this thing started.... obvious thing that I see is no tach/RPM signal and thus no fuel injecting or doesnt detect motor is even in cranking mode.

halp plz!!!

aaronc7

iTrader: (8)

I'm here as well...here's some more info

Car is 01 stock. Ran fine before. This is one of the older reverant units. Same as first gb as far as I know. Nothing displaying in composite , trigger, tooth logger etc. Guy who owned it before had 01 and was running it on his...didn't mod it or anything.

Braineack

iTrader: (62)

why is spark A set to tachout? but it doesnt appear to be getting cas signals whatsoever

cpolly69

iTrader: (2)

bought this used off miatakenji -
hoping it actually functioned and ran a car before i got it -
yeah there's no tach signal - not sure what settings to go through to try to get it to work
the only difference is the firmware, but that shouldn't make a difference the box still has the same map that was on it when i got it

phillyb

iTrader: (8)

hahahahahahhahah
aahahahahahhhahahahahahah

aaronc7

iTrader: (8)

Yeah, I just noticed that Spark out setting. no idea why it is that way. His TS project file just got corrupted though and now he can't even open it.... gonna try again from scratch

Braineack

iTrader: (62)

this is when skype comes in handy, and knowing reverant's contact info.

cpolly69

iTrader: (2)

changed to IGN1... no go. gonna take ecu box apart and look for anything obvious

Braineack

iTrader: (62)

well that wouldn't change the no cas input signals issue. just something i noticed, dont see what reverenat would use tachout for the spark and not the two spark outputs like normal.

aaronc7

iTrader: (8)

everything on the board checks out good wiring from pinout to IGN1/2 and VR2 and OPTO... thinking software issue or somehow CAS went bad or something...

Reverant

iTrader: (10)

Is there a sticker on the bottom of the unit? Almost all of my units (except for a couple which I know) have one.

Please post a composite log.

aaronc7

iTrader: (8)

aballoonflies

SN: 10019

Putting it all back together right now, will get those logs here soon

Reverant

iTrader: (10)

Is this a 01-05 unit? If so, it should have a VVT dongle or VVT passthrough jumpers if you don't have a DIYAutoTune.com VVT controller attached to it.

cpolly69

iTrader: (2)

VVT box is attached and both jumpers are installed. Car is 2001

Reverant

iTrader: (10)

Both jumpers need to be REMOVED if you have the VVT box attached. They need to be installed if the VVT box is NOT attached.

hustler

iTrader: (6)

Show me your dongle.

cpolly69

iTrader: (2)

Welp there you go.. car is running right now. Would have been useful info to have from the guy I got it from. Thanks rev, you're the man. Still looking for TS ini file if you got it handy... it's complaining everytime ecu connects.

thanks again!

cpolly69

iTrader: (2)

you have pm

Reverant

iTrader: (10)

PM me your email address for the .ini file.

Can a mod please add "SOLVED" to the title of the thread?

Reverant

iTrader: (10)

INI file sent. Isn't it nice to have Awesome++ support or what?