MS circuit help required
Anyone with a pcb v3 measure at gnd and 5v in proto area, tell me if that should be open or closed circuit?
|
meaningless if you're talking about measuring impedance (ohms). unless you measure 0 ohms which is a problem.
it should measure 5V when powered though. |
I found the problem, and yes it was measuring at 0 as a completely closed circuit with no resistance. Finally found my issue causing my 5volt reg to blow up and polyfuse to work correctly and disconnect the circuit.
|
and that was?
|
Originally Posted by Braineack
(Post 775772)
and that was?
|
All times are GMT -4. The time now is 08:19 PM. |
© 2024 MH Sub I, LLC dba Internet Brands