ms grounds
ok i have the the 5 grounds 8,9,10, 11, and 19 all connected to one wire comming from the db37, what pin on the ecu should i connect this to??
|
stock ecu ground...
|
whitch one, there are like 4?
2a, 2b, 2c, 2d |
I ran the ground to the stock grounds on the engine near the CAS and FP regulator. You can never have too good of a ground connection.
|
Originally Posted by mschlang
(Post 87052)
I ran the ground to the stock grounds on the engine near the CAS and FP regulator. You can never have too good of a ground connection.
|
so pin 8,9,10,11, and 19 on the ms connector can all connect to the ground near the engine??
|
I grounded them to one of the stock ecu mounting bolts. Also, what gauge wire did you use for your ground? If you connect all of them together in the DB37 (I did) you need to make sure you have a low enough gauge wire to support all those grounds without noise interference.
|
What would you recommend than arkmage?
|
i used like a 10 gauge
|
Originally Posted by cjernigan
(Post 87252)
What would you recommend than arkmage?
|
done
|
I always run the grounds to the battery to avoid spike into the inputs, but as long as there is less than 0.3 ohms in your connection, you are okay.
|
All times are GMT -4. The time now is 10:16 PM. |
© 2024 MH Sub I, LLC dba Internet Brands