MS LABS MS2 Extra CAN Bus AIM SOLO DL
 

I am trying to hook up my AIM Solo DL to my MS labs MS2 Extra but I am not getting a signal to the Solo. The wiring pin out I have from Reverant shows the CAN L/H on pins 8 and 9 on the DL37 which is where I have wired to but no luck. I have CAN functions in Tuner studio so I think the firmware I am running supports it (Pre Bata 3.3.2). I tested my wiring to the pins of the plug and all is good.

What else could I be missing?

Thanks

I found the area in TS to enable broadcasting of the CAN BUS, but this caused an issue with Extra board. I am guessing that there is some sort conflict between the two? I was under the impression that the CAN was almost plug and play, I guess that is not the case. Has anyone else hooked up to the CAN bus to retrieve data?