MS2 wont flash
#1
MS2 wont flash
So i got my new MS2 built and i used my old MS2 daughter board. I went over the whole build before i even powered it up. Everything looked good, so i powered it up and everything seamed good. The lights flash once when i turn the key on. So i take it everything is good, so i try and flash the ms2 but no matter witch way i try to flash it i cant get the MS2 to communicate.
Any one know why my ms2 is not communicating?
Any one know why my ms2 is not communicating?
#5
Supporting Vendor
iTrader: (33)
Join Date: Jul 2006
Location: atlanta-ish
Posts: 12,659
Total Cats: 134
You need to do the serial loopback test that are called out in the build manual to try to rule in/out what could be wrong, but with the way I understand that you had grounded your MS2 through the EDIS module, I wouldn't be surprised if the processor is fried.
http://www.msextra.com/doc/ms2extra/serial_setup.html
http://www.msextra.com/doc/ms2extra/serial_setup.html
#8
Okay i got a new daughter board and check everything over and over more time then you could shack a stick at, and still no flash. WTF What could be wrong matt went over my wiring and i fixed a few small things, the ecu looks fine no burning or any of that but still cant get it to flash. I tried 2 laptops and 1 desktop still nothing.
#13
Okay anyone know what could be wrong??? I went over the board with a multimeter and everything reads good power, grounds, resistors, diodes, and capacitors. Could i have a faulty bored? I have tried other laptops and desktops just using the serial cable.
Matt anyway i could mail you my MS2 and have you guys look at it? Its the last part i need for my car i have everything done besides this MS.
Matt anyway i could mail you my MS2 and have you guys look at it? Its the last part i need for my car i have everything done besides this MS.
#15
That's pin 1 (Vsyn). Should be easy to trace back:
Damn image won't show: http://www.megamanual.com/ms2/v3pcb_6.gif
Damn image won't show: http://www.megamanual.com/ms2/v3pcb_6.gif