Check out my logs and msq
04-30-2010, 08:54 AM
#1
Elite Member
Thread Starter
iTrader: (8)
Join Date: Jun 2009
Location: Albany, NY
Posts: 1,461
Total Cats: 4
Check out my logs and msq
msq, logfile, and a jpg of something which concerns me are attached. I'm looking for feedback on anything in my msq, but idle control and accel/decel is of interest to me.
Also, the log and the photo is of a dyno pull. Keep in mind these are gas equivalent AFRs, I'm using E85. In the photo I have the time bar at a spot I'm concerned about. Self explanatory, but it's low boost (3 psi), around 3000 rpm, right after we come out of tps enrich it looks like it goes lean for what, like 1/2-3/4 second, then back to ~low 11s. This is very consistent in all the logs for ramp runs. I'm also thinking I can pull a tiny bit of fuel in boost to keep it completely out of the high 10.x AFRs.
Whatcha think?
Also, the log and the photo is of a dyno pull. Keep in mind these are gas equivalent AFRs, I'm using E85. In the photo I have the time bar at a spot I'm concerned about. Self explanatory, but it's low boost (3 psi), around 3000 rpm, right after we come out of tps enrich it looks like it goes lean for what, like 1/2-3/4 second, then back to ~low 11s. This is very consistent in all the logs for ramp runs. I'm also thinking I can pull a tiny bit of fuel in boost to keep it completely out of the high 10.x AFRs.
Whatcha think?
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM
