Serper3

iTrader: (3)

Hi guys. i have been building by stim for the last few hours and i am almost done. i need a new tip for my iron so i will finish probably tomorow.
my soldering skills... welll lets just say i dont have any. really hope it works ok though.
not sure if this stim will work since this is the 1.3 version.
another thing, i was bending the lead on q1, in the 1.3 directions. the middle lead broke. on the package it says trans. npn 200 ma to -92. can i pick this up at frys or radio shack? what do i need to tell them? how much will it cost? thanks alot and here are the pics. maybe you guys can give some pointers with my soldering.
thanks alot!

Serper3

iTrader: (3)

Anyone?!

icantthink4155

iTrader: (12)

You need a part number, I dont see it being more then a couple bucks but I have no idea. On a side note I got some completely unrelated transisters on ebay for 8 cents each.

Serper3

iTrader: (3)

Wait I need a part number? Would the store have its own part number? Where would I get the number? I still have the bag that the component came in that has the description on it.. Will that be enough?
Thanks!
Any more info/help/advice?

AlexO35

iTrader: (7)

That should be. Bring the component also. It really all depends on how good the reps are at the store.
--Alex

Tremiata

iTrader: (1)

http://www.jbperf.com/JimStim/jimstim-bom_v1_3.xls

This I believe is the stim parts list.

Serper3

iTrader: (3)

ok thanks alot guys... i did have the part number on the baggy from diy. i whent to radio shack and they had the part! i finished the stim and started on the actual ms build!!! thanks to everyone for the help!