MS Noob Ready to roll
#1
Senior Member
Thread Starter
iTrader: (1)
Join Date: Sep 2008
Location: Tucson, Arizona
Posts: 883
Total Cats: 56
MS Noob Ready to roll
I'm a noob in general but particularly to MS. I have an MS I bought a long time ago but the miata project fell flat. I'm back on it. This time with new motor and cops.
It's a 99 Motor in a 90. I am using the stock tb off the 99 and the cas off the 90. I've wired in the 99 tps. I haven't driven the car yet but am ready to. I just installed the wideband and updated the table accordingly. Please look over my msq and let me know if there is anything I should change before I go for a spin. My wastegate is open right now and I didn't plan on boosting really until the motor is broken in. Especially since i'm an MS noob.
I have stock 99 injectors as well.
On a side note My CAS is all the way towards the passenger side and I can't get the timing to 10 degrees. It's been a while since I put the motor together so I suppose i'll check my timing belt but throwing it out there. It's sitting @ about 8 degrees. Idles fine right there.
It's a 99 Motor in a 90. I am using the stock tb off the 99 and the cas off the 90. I've wired in the 99 tps. I haven't driven the car yet but am ready to. I just installed the wideband and updated the table accordingly. Please look over my msq and let me know if there is anything I should change before I go for a spin. My wastegate is open right now and I didn't plan on boosting really until the motor is broken in. Especially since i'm an MS noob.
I have stock 99 injectors as well.
On a side note My CAS is all the way towards the passenger side and I can't get the timing to 10 degrees. It's been a while since I put the motor together so I suppose i'll check my timing belt but throwing it out there. It's sitting @ about 8 degrees. Idles fine right there.
Thread
Thread Starter
Forum
Replies
Last Post
StratoBlue1109
Miata parts for sale/trade
21
09-30-2018 01:09 PM