ms2 Car won't start "AC pin error/conflict"
 

So i've got a new gremlin with the car. I went out to start it today and it just turned over and over and wouldn't start. I cycled the key to run and I noticed that the fuel pump primed like it usually does, but then primed again a couple more times. I hooked my laptop and I was presented with this upon opening tuner studio:


https://www.miataturbo.net/attachmen...ine=1433552191

I tried starting a new project to reload the firmware and the car started up and ran fine. I went out to start the car a few hours later and now its giving me the same AC pin error/conflict message.

ALED is used for the A/C, what did you try to do that uses the ALED output?

wait, you cant set every output to ALED?

You saw the thread where the other guy had his AC out set to CLT>98c?

lul