View Poll Results: What do you tune with
Auto-tune
6
12.77%
MLV
22
46.81%
Change each cell 1 by 1
15
31.91%
I dont tune my shit, i pay people to.
4
8.51%
Voters: 47. You may not vote on this poll
How do you tune?
#1
Elite Member
Thread Starter
iTrader: (7)
Join Date: Jan 2007
Location: Renton Washington
Posts: 1,731
Total Cats: 4
How do you tune?
Im wondering how people tune their ****. I currently use MLV when the target tables transfer over from my MSQ. Sometimes the tables don't show up in MLV, so i use Autotune. I am just curious what other people use. What is the best to tune with?
#11
I use DLL. For the low map and cruise zones (upto 110kPa) I adjust each cell so that the VE table is a touch rich in that cell (say by 2%). For power tuning I carry out repeated WOT runs on the same stretch of road and adjust timing and fuel so that I achieve maximum area under the torque curve without knock. The water/meth injection makes this a little more complicated mid you.
#13
Cause i get someone else to drive while im on a base map, andi adjust everything until it feels right. I've also done it with one hand on the keybaord between shifts but i dont like doing it like that it kinda makes you swerve alil from time to time, when you look at the screen. After the tunning session feels strong and consistent i pull over save it and take a log and just watch my readings in general to see if anything is out of whack. After i get home i pull the log and go over it second by second looking for anomalys that would or could present themselves as running problems.
Thread
Thread Starter
Forum
Replies
Last Post
StratoBlue1109
Miata parts for sale/trade
21
09-30-2018 01:09 PM