Diypnp 2.7v at 12v rail
04-27-2015, 07:26 PM
#1
Senior Member
Thread Starter
iTrader: (5)
Join Date: Nov 2013
Location: Wisconsin
Posts: 655
Total Cats: 70
Diypnp 2.7v at 12v rail
Helping a friend troubleshoot his mspnp diy and we are attempting to boot and load firmware. It won't boot, and I'm getting 12v rail showing 2.7v..
I've tried putting 12v directly to the 12v rail, my DMM shows 12v on the supply up until I put it on the board and then it drops..
The solder joints all look pretty good. The couple questionable ones I checked with my DMM on ohms and they're not touching.
Ideas?
I've tried putting 12v directly to the 12v rail, my DMM shows 12v on the supply up until I put it on the board and then it drops..
The solder joints all look pretty good. The couple questionable ones I checked with my DMM on ohms and they're not touching.
Ideas?
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
Mikel
MEGAsquirt
4
09-28-2015 04:46 PM
