'92 1.6 Diypnp Launch control
01-08-2011, 05:35 PM
#1
Newb
Thread Starter
Join Date: Mar 2009
Location: Birmingham,England
Posts: 43
Total Cats: 0
'92 1.6 Diypnp Launch control
Just finished building my diypnp and the only thing (i think) left to do is install the launch control circuit.
I just wanted to make sure that the clutch switch ecu connection on my car is 1V?
If so i presume i need to go from 1V on the connector board to input 2 IN. Then from input 2 out to pe1?
Thanks
Mike
I just wanted to make sure that the clutch switch ecu connection on my car is 1V?
If so i presume i need to go from 1V on the connector board to input 2 IN. Then from input 2 out to pe1?
Thanks
Mike
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
Mikel
MEGAsquirt
4
09-28-2015 04:46 PM
