MS3 Starts/Runs rough, Rich as $%#$ nothing helps
6 Attachment(s)
95 NA
Stock engine / Injectors MSLabs MS3Basic 1.2.3 Firmware Innovate MTXL Wideband GM IAT Car runs great on stock ECU, Starting the car on the MS3, It starts but runs very rough (like its on 3 cylinders) insanely rich 8:1 - 9:1 Changes to VE table or Required fuel seem to have no effect. Checked ignition timing last time I tried to get it running right, set MS to 10deg fixed then used a timing light and the crank pulley read 10deg so this isn't a timing issue I don't think Maybe there is a setting im missing or something, I'm pretty fed up at this point lol Here is a data log, MSQ and a Composite log of cam signal for you guys to check out |
Post screen shots instead of links for us lazy assholes.
|
disconnected map vacuum line?
|
Originally Posted by 18psi
(Post 1097909)
disconnected map vacuum line?
|
and its tapped to the vacuum source correctly and no leaks? cause that's the 1st symptom of super richness: map reading too high.
is this a fresh install or did it all of a sudden start doing this? |
40kpa while "idling". This is a fresh install, ive never been able to get it to run anything but pig rich
|
Emailed.
|
Rev sent me a tune with a VE table 20 points lower in the low KPA area up to 2k rpm. This had no effect still running super rich 9:1 plenty of white smoke out the tail pipe
|
Fresh plugs using tune with lowered VE table, ran it for 30sec still pig rich at 9:1, lowered whole VE table 20 points more...no change still 9:1
anyone every have any issue similar to the one im having ? |
What exactly are you doing with table switching?
|
Im not using table switching.
|
Do you happen to have IdleVE switched to on and trying to change the normal VE table?
|
IdleVe is off
|
Originally Posted by Gt2560rMiata
(Post 1098227)
Im not using table switching.
|
They are not active per the data log?
|
Originally Posted by Reverant
(Post 1098353)
They are not active per the data log?
|
Tryed different tune making sure table switching was off. Had no effect.
|
What had no effect?
Did you reduce the values in fuel table VE1 and or reduce ReqFuel? |
Turning of table switching, which wasn't active but enabled. Ive cut reqfuel in half, also tried uping it 50% either way it wants to run poorly at 9:1
|
Stuck injector?
|
All times are GMT -4. The time now is 11:33 PM. |
© 2024 MH Sub I, LLC dba Internet Brands