MSPNP9093 with a 1.8 swap
I've installed the MSPNP9093 in my 92 with a 1.8 out of a 94.
Now I need to decide ... Should I use the 1.6 base map, & modify it for the 1.8 or should I install the 94 base map & modify it. Any suggestions on which is the easier route? The engine is mostly stock & still has the MAF. I have a GM IAT ready to install, just haven't done it yet. Maybe I'll start there. |
Install the GM IAT and use the 94-95 firmware so the idle settings will be correct for the 1.8 IAC valve.
|
the only change to make allowing the TPS to read.
|
The car's running with a 1.6 IAC, TB combo with the FM adapter plate.
So is it better to start with the 1.6 maps for the AFM, and IAC... then put in fuel/timing maps from the 1.8 base maps? Dave, |
Originally Posted by steelrat
(Post 262302)
The car's running with a 1.6 IAC, TB combo with the FM adapter plate.
So is it better to start with the 1.6 maps for the AFM, and IAC... then put in fuel/timing maps from the 1.8 base maps? Dave, I guess that's the question I should have asked.. :noob: |
i don't know if they're the same, but I posted up the settings for iac control for a 99 motor in a similar thread.
|
All times are GMT -4. The time now is 03:13 AM. |
© 2024 MH Sub I, LLC dba Internet Brands