MSPNPPro-MM0105: Coolant Temperature Output
MSPNPPro-MM0105
I'm looking to adjust the coolant temperature output values so I can run an aftermarket gauge. I'm using the stock 2001 temp sensor and harness. Coolant temp gauge is wired through the X-16 connector. Tuner studio shows 170*F, Autometer gauge shows 255*F Any thoughts? |
Your autometer gauge needs its own sending unit. Disconnect it from the ECU.
|
What Ben said.
Your autometer gauge, like nearly all temperature gauges, isn't looking for a voltage input, it's looking for a variable resistance to ground. Your ECU cannot emulate this. (I'm not aware of any that can.) Long story short: install a temperature sensor appropriate to the gauge. |
You MIGHT be able to spoof it with a generic PWM output. But this is going to take some trial and error.
|
Use the ECU to drive a stepper motor on a potentiometer! :)
--Ian |
Looks like adding the autometer sensor is the way to go. Thanks for the input guys :-)
|
All times are GMT -4. The time now is 05:45 AM. |
© 2024 MH Sub I, LLC dba Internet Brands