mine had two black wires and from what i read it was non polar

it sounds like you might have tapped the sensor into the wrong spot.


the Red/Black wire (singular) is the AIT signal wire on the harness.

the Black/Lt Green is the ground.


from DIY:
http://www.megasquirtpnp.com/models/...e/IMG_7222.jpg


Doesn't matter which goes where. But it seems like me like you tapped into the RED and Blk/lt green or blk/blu wires.



if you'd had the laptop connected you'd have probably seen 0° in the intake ;)

i dont remember for sure what the colors were, i went based on that picture that you posted, i cut the third and fourth wire so as long as it doesnt matter which one connects to which other one, i should be ok, no?

yeah if tapped into the ones above you'll be fine. Actually I guess if the AIT wasn't seen by MS it wouldn't run at all. So I sill think it's just a matter of tuning your fuel map.

ok, thats good enough for me...ill play with it some more friday night

i have an idea, maybe you should plug the damn thing in for it to work!!! just laying there is not going to do much, hehehehe. :bigtu: just kidding i am hoping i can help you this weekend to figure the thing out. call me when you get here. well make it work. all we need is to buy a pussy magnet j/k. :bigtu::beer:

tried to install the pussy magnet this weekend, it fried my coil, lol

on the serious note, the harness turned out to be faulty indeed... :confused: yeah