DIYPNP, Launch control - how to ?
#6
Elite Member
iTrader: (1)
Join Date: Jun 2006
Location: Warrington/Birmingham
Posts: 2,642
Total Cats: 42
Minimum you need a switch wiring in to activate it. Mine uses the clutch switch.
I also use VSS to disable it above 10mph, so during hard driving it doesn't accidentally become engaged during a gearchange.
I also use VSS to disable it above 10mph, so during hard driving it doesn't accidentally become engaged during a gearchange.
#7
Boost Czar
iTrader: (62)
Join Date: May 2005
Location: Chantilly, VA
Posts: 79,493
Total Cats: 4,080
for launch i'd do 1L into input 2 IN, then input 2 OUT to FLEX.
that's it.
for you idle question in PM, all you need to makre sure is that you have 4Q to IAC. and you shoudl have installed a diode on the IAC jumper by where you added the VR and OP- pull ups on the bottom right side of the board.
thats it.
that's it.
for you idle question in PM, all you need to makre sure is that you have 4Q to IAC. and you shoudl have installed a diode on the IAC jumper by where you added the VR and OP- pull ups on the bottom right side of the board.
thats it.
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM
Mikel
MEGAsquirt
4
09-28-2015 04:46 PM