Pnp2 not seeing variable tps signal
Details:
Diy auto tune pnp2 Wells tps I have the sensor installed and wired in as described in multiple diy's. Using a multimeter I can see the voltage value change on the signal wire when I rotate then sensor. Why I go into the tps table and try to retrieve values it always reports back with zero regardless of throttle position....anyone have any ideas? |
Is your MS wired to run a VTPS? You have to connect some ports inside the MS.
|
what year car?
|
Originally Posted by Braineack
(Post 1281755)
what year car?
I was under the impression (perhaps incorrectly) that the diy autotune pnp2 was configured to be capable of using a variable tps without having to modify the ecu? |
Got it all worked out. Needed to add a jumper to the circuit board. Did it and it works as it should.
|
To clarify for others reading this thread - there's a pull off jumper to turn VTPS input off or on inside the Gen 2 MSPNP for the '90-'93 cars, but no soldering is required.
|
All times are GMT -4. The time now is 09:12 AM. |
© 2024 MH Sub I, LLC dba Internet Brands