Good idea, ill tinker with that tomorrow, I loaded the HR_10g code again and noticed with my stim that when i turn the RPM knob the injector lights now fire. as far as i know the stimulator results are promising.

I will report back in the morning!

Can you upload your current tune?

using the basemap on this page:

http://www.megasquirtpnp.com/mspnp_downloads.htm

specifically, the one labeled

"MSPNP_MM9697_Base_Map_012808.msq"

edit: suppose it would make sense to post a link!

Hmmm. So you didn't modify it to trigger your ignitor? You just loaded firmware on it and plugged it in?

Had no idea I needed to. I've loaded a basemap and played with the timing settings if that's what you're asking.

Edit: I see now, there should be some extra things soldered to my megasquirt in order for me to use stock ignition. I suppose I need to send it off to have them added

how do you expect it to run your miata then?

pictures of your megasquirt board please

Not a clue, I assumed the one I ordered would work, but as it often turns out, I learn the hard way.

I contacted diyautotune about modding it to match the requirements of the miata