MostHated

Hello all, I am not sure if anyone here would know, but you guys know Miatas well and how the MS needs to be built for them, is there anything special about how the boards are built or setup (using different parts or pieces / components in the kit) that I might have to change / remove / add to use on a different car? I got a really good deal on it (never installed, I believe it was a kit by Braineak, so it has the premade Miata harness). I bought the Nissan breakout board so I can just remove the pins from the Miata harness and move them over to the 240 one. I am not sure what else may need to be done though. I plan to run these coils instead of a distributor (ign-1a ignition coil).

If anyone has any insight I would greatly appreciate it! I will post this on the 240 forums as well to see if anyone has any info from the 240 side as well.

Thanks fellas!