MS Problem - Car won´t pass 3k rpm
08-17-2010, 06:09 PM
#1
Newb
Thread Starter
Join Date: May 2008
Posts: 33
Total Cats: 0
MS Problem - Car won´t pass 3k rpm
I´ve a MS from Brain.
The firmware is the hr10g and have a 4 bar MAP.
The car is a NA6 from 1993(EU car) with a BP4w engine without MAF.
VICS is disconnected.
The Problem is that the car won´t pass 3000rpm, it has lots of hesitation and cannot pass that. Between 1000 and 3000rpm runs... but it´s not very smooth.
The following maps is what came in the MS.
how can i set the DIY basemap and set the right range for me?
I´ve try to put the DIY basemap in the MSPNP website but I got the following errors.
I still tried to upload that map but without sucess, seems that the MS won´t accept it.
can you help me scale and put a right spark and VE table for my NA car… I don´t have turbo.
Can someone help on this matter? supply me a basemap to my car?
thanks
The firmware is the hr10g and have a 4 bar MAP.
The car is a NA6 from 1993(EU car) with a BP4w engine without MAF.
VICS is disconnected.
The Problem is that the car won´t pass 3000rpm, it has lots of hesitation and cannot pass that. Between 1000 and 3000rpm runs... but it´s not very smooth.
The following maps is what came in the MS.
how can i set the DIY basemap and set the right range for me?
I´ve try to put the DIY basemap in the MSPNP website but I got the following errors.
I still tried to upload that map but without sucess, seems that the MS won´t accept it.
can you help me scale and put a right spark and VE table for my NA car… I don´t have turbo.
Can someone help on this matter? supply me a basemap to my car?
thanks
Last edited by Baal; 08-18-2010 at 02:21 PM. Reason: no replys
Reply
0
0
08-25-2010, 02:15 PM
#6
Newb
Thread Starter
Join Date: May 2008
Posts: 33
Total Cats: 0
i did a short log today... after i upload this new msq from mspnp website the 96-97
it does the same thing... at 2500rpm has lots of hesitation and the spark goes from 26 to 6 degrees... and keeps doing this...
i will install my lc1 soon so i can gather more information.
if you can point me in the right direction i appreciate.
thanks
Pedro
Reply
0
0
08-30-2010, 01:52 PM
#8
Supporting Vendor
iTrader: (33)
Join Date: Jul 2006
Location: atlanta-ish
Posts: 12,659
Total Cats: 134
I hope that you won't be going into boost on that ignition advance table--the MAP scale isn't very motor friendly. Take a look at our MSPNP advance tables for a better start...
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM
JesseTheNoob
DIY Turbo Discussion
15
09-30-2015 02:44 PM
