85z28

iTrader: (2)

Got the install done for my 1.6 and it ran for a minute, sputtered and died. Now the gauges are stuck and the RPMs read extremely high..... stock 1.6, COPs and AFM removed. What did I do wrong?

Braineack

iTrader: (62)

65,xxxRPM high?

85z28

iTrader: (2)

Yes sir.

Braineack

iTrader: (62)

Do i tell you to read the maunal or give you the answer?

85z28

iTrader: (2)

Well, I got it fixed... somehow. The car is running, it surges at idle really bad. Can you point me in the right direction? I made sure the injectors were at 11.2... I'm trying to learn, just need a hand.

Braineack

iTrader: (62)

ah, so you cleared your conflict error!

as for surging I don't undestand, do you mean the AFRs are all over hte place, or the RPMs?

as for 11.2? you mean you set the required_fuel to 11.2? or tuned for 11.2 AFR?

85z28

iTrader: (2)

RPMs were surging and it won't stay running. Req fuel is 11.2. I used the diypnp map for a base map. Could something be because I have MS2 extra and that was made for regular MS2? I also moved base timing to 10 and moved the AFR up to 15 in the idle area.

Braineack

iTrader: (62)

idle richer to smooth it out, but sounds like some idle tuning is in orde.r I'm assuming the idle PWM% isn't stable?

85z28

iTrader: (2)

I played with it a bit, but don't really know where to start with it.

So you're saying idle richer that 15 AFR?

Techsalvager

get us data logs of current issue
Allways log data if tuning or there is a issue you want someone to see!
Don't forget to upload the tune with it

85z28

iTrader: (2)

Any chance y'all have a good pwm map for a 1.6

Techsalvager

I say screw the idle control now and use the idle screw to hold it at an area instead. Get fueling done correct in those areas.

Braineack

iTrader: (62)

nooooooooooooooooooooooooooooooooo.

dont touch the idle screw.

85z28

iTrader: (2)

That ******* code is back. I went to communications> mini terminal> turned off and on port. No luck.

Techsalvager

upload your tune to here.

85z28

iTrader: (2)

So it finally told me a boost (contol?) pin configuration error, where the hell can i fix that?

Edit, how do I upload a map?

Braineack

iTrader: (62)

make sure boost control is not set to a pin that's utilized by something else.

or just turn it off for now. diypnp basemap?

85z28

iTrader: (2)

Yeah, that's the exact tune I'm using. I feel like that is part of my problem that it was built by Reverant and I'm using the DIYPNP map. I'm probably wrong though.

85z28

iTrader: (2)

Well, it won't idle at all..... it fires off then dies. I can get it to run if I hold the throttle.

Techsalvager

Are you logging any of this when you are testing?