So close to spark control....
I've hooked up the spark control (2 wires should be easy right?) car started after a bit of peursuasion from stone cold, and then it ran!
except it sounded rough, so whilst it was running, I lulled the plug leads stareting from the front of the engine, 1st one as soon as I pulled it i heard clicking/arcing so that one is geting spark. next one, nada, nothing, same with three, then on lead 4 I get arcing again. So I'm running on 2 cylinders (and pretty smoothly considering...) both coils are firing, but only on one side of each coil :( Pluggin in the stock ECU's control makes everything normal again. yet again Help! any ideas? I'd love to get spark going now and have everything tidied away! ;) many thanks in advance! Richy |
just double checked my wiring diagrams, I'd wrongly assumed that coil A controlled 1 & 2 and B 3 & 4.
A controls 1 & 4 and B conrtols 2 & 3, so I have a problem somewhere with my coil B output :-( Could it be config based? or is it more likely something to do with my mdifications on the MS board it's self? |
I'm even more confused now,
accoring to a DB37 to stock ecu pinout I've got Coil A which is the brown wire should go to the wire on pin number 29 on the DB37 and coul B (brown yellow) to pin 31 on the DB37 Now pin 29 goes to IAC2A according to the external wiringdiagram I got with my prebuilt loom. and pin 31 goes to ICA2B looking at this picture of my modifications http://www.asbi52.dsl.pipex.com/megasquirt/MS30.jpg I've got one wire going into ICA2B which is the coils that are working, but I've not got anything plumbed into ICA2A..... However I can't actually see anything wrong with my mods, so why don't I have spark on plugs 2 & 3? |
I've gone over everything a million times then suddenly this sentance jumps out at me on Jerry site
When wiring up your ECU later: Spark Output A will come out on pin36, and Spark Output B will come out on pin31. and specifically the bit in bold. I'm a dumbass, and it now works perfectly MS rocks! I've replied to myself 4 times in my own thread, tho writing it all down helped to collate my thoughts I think... Thanks for putting up with me! |
Heh, keep doing it... then when i get to that point... i remember :p
|
lol will do! ;)
|
All times are GMT -4. The time now is 09:41 AM. |
© 2024 MH Sub I, LLC dba Internet Brands