Stock 96 Na Diypnp Base Map
 

I picked up a Diypnp for my stock 96 miata not to long ago and had everything installed last weekend. Since then I've download the mspnp2 base map called "MS2E v3.3.1a mspnp2-mm9697" but now when i go to load it onto the diypnp using tuner studio about 40 warnings come up. Currently the diypnp is on the latest ms2/extra firmware 3.4.2 which is why I think i'm getting all those errors from the older base map. My problem now is understanding where/how everything is labeled on tunerstudio such as amap_table1, knk_trtd, fmap_trim2doz, etc. If anyone can help me figure out where everything is at or point me to a updated basemap I would definitely appreciate it!

https://cimg0.ibsrv.net/gimg/www.mia...b17499b7fe.png

I had the same issue a week ago. I asked Phil at DIYAutotune. Got the following response:


"You will want to load the old tune file to the 3.4.2 project and update the tune file for the current firmware.

Simply load the tune file and it will take all the settings that will cross over, ignore any errors when loading tune files."


Let me know how it goes. I'm trying to get my 96 running on DIYPNP. Mine runs super rich and stalls out almost immediately.

DIYPNPs and MSPNPs have their own output pins, so some items may end up on the wrong pins. Just give everything a sanity check.

Bringing this back as I have the same problem.

Am I wrong to assume that settings aren't going to transfer? I looked at the config and it has the engine listed as a 2000 cc with 0cc injectors


Do I have to roll back the firmware to get the correct settings before I can upgrade back to 3,4..?