Tables should say kpa?
 

Still on the base map for megasquirt and this is probably a stupid question but, my buddy showed me his afr table to base off of and I noticed he had map kpa on the side of his table. None of mine say kpa on the left hand side just fuel load , ignition load etc. Is there anyway to get kpa on the side?
https://cimg9.ibsrv.net/gimg/www.mia...ad401cd92.jpeg
https://cimg0.ibsrv.net/gimg/www.mia...441803e88.jpeg
https://cimg2.ibsrv.net/gimg/www.mia...3b68bf786.jpeg

Load=Manifold pressure. They're the same thing.

Those tables are awful though.

Looks fine to me. AFR table looks fine, although I don't personally sip the "lean in cruise" koolaid. Fuel map looks good, needs some hand-finishing but it looks exactly like what a good post-autotune fuel map will look like where the time spent in low-vac and transition cells makes for spotty autotune adjustments. Ignition map is hyper-conservative but that's better than the alternative. That tune is like 90% done. It needs about 90 seconds of hand-blending, 10min of spot-checking the fuel map on a steady-state dyno, and then 2hrs or so of pulls to dial in the ignition map.

I appreciate it 😅 but really I’ve only adjusted idle and that’s about it l. I guess the base map is pretty good then 🤣