Tach and Idle valve
93 1.6 miata
MSII v.3 unassembled kit... OK, i'm building the thingamabobber and first option... Tach Signal: Hall effect or VR? I chose Hall optical, is this correct? I don't understand IAC stepper, our engine isn't stepper right, ... erm, C-12 is empty (tach signal?) Oh and i caught a mistake (step 54 or 55), with the whole thing about Ford and Mazda, i put in a 2.49k Ford resistor instead of the 2.2k Mazda for the sensor table, go figure, but my question is would i have to de-solder this and use the correct one or can this be recalibrated in MegaTune? |
I'm sorry if this was a stupid post, i just found my answers... i still don't know whats the deal with the IAC stepper...
|
Originally Posted by Mouglie
(Post 76226)
I'm sorry if this was a stupid post, i just found my answers... i still don't know whats the deal with the IAC stepper...
|
Originally Posted by Aussie Driver
(Post 76229)
we don't have an IAC stepper
|
We have a 3-wire Bosche IAC/ISC valve. If you do the PWM idle board mods then MSnSE will happily control the idle.
|
kool... i'll do the PWM mod...
but i just went back through the steps and i skipped step 22... to make this quick, should i use a gm sensor or what should i do in this step? http://www.megamanual.com/ms2/V3assemble.htm arhhh i see red letters, i don't wanna burn anything, ok i got a MSII so that means i'm not burning anything right? (i'll take a brake now) thanks in advance... |
Originally Posted by Mouglie
(Post 76251)
kool... i'll do the PWM mod...
but i just went back through the steps and i skipped step 22... to make this quick, should i use a gm sensor or what should i do in this step? http://www.megamanual.com/ms2/V3assemble.htm arhhh i see red letters, i don't wanna burn anything, ok i got a MSII so that means i'm not burning anything right? (i'll take a brake now) thanks in advance... |
All times are GMT -4. The time now is 08:15 AM. |
© 2024 MH Sub I, LLC dba Internet Brands