90 Turbo

iTrader: (3)

Ok so I have been searching for a timing map that is pretty conservative for my swapped in 04 engine. What do you guys think of just using the 99-00 base timing map diy provides for the diypnp 99-00. Would it be safe?
Any one have a safe map they could post.
Thanks
Brian

hustler

iTrader: (6)

Yes, pull some spark.

hustler

iTrader: (6)

Start with this on 93-octane.

If the car is ready, I might be able to get your car on the dyno this weekend for a small contribution to my swap-fund.

90 Turbo

iTrader: (3)

Thanks for the map Hustler.
It will not be ready this weekend but will be next. I can help with swap fund and swap if ya need a hand.

hustler

iTrader: (6)

MAP is pressure, this is a table.

I'd love to come help you today, but I'm so tired from swapping engines in a one-car garage; I'm sure you understand. I have a small water leak somewhere that I have to chase today.

90 Turbo

iTrader: (3)

OK i must be slow in the head. I cant get the base 99-00 map to download off diy's site and hustler your map looks more agressive than the one I run on the 9.5-1 1.6. Can some one please post a picture of there map and I will just fill in the blanks in my map.
or please post a msq with a conservative 99-05 timing map. I just want something i can take 3 degrees out of and know I will not have knock till I get detcan/knocklite hooked up.
Please help she is almost back together and I will be starting her for the first time this afternoon.
HELP.

90 Turbo

iTrader: (3)

Does this seem right. I think it is the table hustler sent me?

hustler

iTrader: (6)

If you want to take out more spark do it. I run that spark table on 91-octane in a 99 engine, +3 degrees up top. That spark table is probably fine.

90 Turbo

iTrader: (3)

Cool thank hustler. On the left side the pressure/map side your only goes to 100 or atmospher.
Is this a NA map?
I have a 2560. How do I adapt it to 10-12psi?

Also some one with 01-05 vvt engine and a turbo please please please post up a map or just the base map from diy or begi. I cant get them to down load or find them. This thing is about ready to be started (still got to but the radiator in and wire VVT tunner but other than that shes ready) and I dont have a conservative timing map to use.

90 Turbo

iTrader: (3)

Well she runs. Its a little rans its rought and back fire on decel. Its pretty load.
the aem wide band is not synced with the tunerstudio. It reads .2 to .4 to high.
It ran with out any miss at all with out the intercooler piping hooked up but now with 1.TB it is running a little rough and really rich the autotune just cant get it back in line

absRTP

iTrader: (12)

Good to know you did it!

I hope I'll be able to make mine start this week end :-)

Can you show me what map you used for spark and what injector are you running on this Z3?

90 Turbo

iTrader: (3)

here is my msq from a couple days ago. I will load another one soon.

absRTP

iTrader: (12)

Thanks buddy!

absRTP

iTrader: (12)

what about the other one, does it end up being better?