TPS mod on DIyPnP
right now there is a resistor between TPS and VR-
I understand I remove this resistor. Then run a jumper to my TPS signal pin from the TPS solder point. I also need a gnd jumper. Then do I use the solder point marked vref near the "boot" section of the board. Or do I use the VR+ two holes to the right of TPS? |
Dunno what your on about, vr+2 is for vr input conditioning, but to fit a variable TPS, remove said resistor, then wire gnd, tps sig and 5v vref to the corresponding pins on the tps.
Simples |
All times are GMT -4. The time now is 06:22 AM. |
© 2024 MH Sub I, LLC dba Internet Brands