troulbleshoot TS connection issue
 

New to MS. I have a MS-3 that has been previously tuned by an outside professional. I would like to datalog a track session, however I can't seem to obtain a connection of the MS-3 to tuner studio.

This seems pretty straight forward. I have purchased the upgraded version of TS. I'm using a printer cable (square end///USB) to connect. I plug everything together; Start up TS; start car. The prompt says not connected.

I've tested the printer cable. It works fine for a printer.

Q: Do I need some sort of update to TS? Q: Do I need to use a different lead? Q: Is there some "captain obvious" solution that I've missed?

What kind of computer.

If windows install this:

Virtual COM Port Drivers

Do you have the vehicle project and stuff open on your computer already? Or new project.

Post a picture of the communication settings.

Communications menu->settings.

Thanks. I'm in!