|
Originally Posted by Techsalvager
(Post 712177)
just remember will cranking under set rpms, spark timing is advanced +10 on the already fixed number
|
If you try it, and it doesn't solve your problem, are you any worse off than you were before you tried it?
|
Originally Posted by fooger03
(Post 712182)
If you try it, and it doesn't solve your problem, are you any worse off than you were before you tried it?
are you referring to one thing in particular? i'm planning on trying all these things. |
When I was trying to figure out if it was a lean condition, I played with req fuel. Told it I had 180cc injectors instead of 230cc. That way the fuelling goes up globally. Got it running for a bit, until I got a new fuel (richer) VE table.
|
1 Attachment(s)
these settings look ok?
|
change the cranking RPM to 350 and req_fuel to 13.0, and see what happens.
keep secondary fuel load disabled. do you have a narrowband or wideband? Never seen the TPS do that... |
Narrow band
|
i appreciate everyone's help. i got it running today.
i adjusted the req fuel and set the cranking rpms to 350 like brain suggested , and it fired up. it idled pretty low and a little rough, so i bumped the req fuel up to 13.2. idles pretty smooth around 850rpm now. |
one thing that i noticed is that it sounds different than it used to. the best way i can describe it, is that it sounds kind of like a motor boat. Im hoping it's just the timing, which im going to set tomorrow...
|
well make sure you're firing on all 4.
|
| All times are GMT -4. The time now is 07:17 AM. |
© 2024 MH Sub I, LLC dba Internet Brands