Can you verify my wiring for seq spark please?
#1
Junior Member
Thread Starter
Join Date: Jan 2014
Location: Port Saint Lucie,FL
Posts: 476
Total Cats: 12
Can you verify my wiring for seq spark please?
Spark A to Cylinder 1, green
Spark B to Cylinder 3, brown
Spark C to Cylinder 4, white
Spark D to Cylinder 2, yellow
Right now I have the ms3 running wasted spark with my fab9 COP PNP setup. It looks like cylinders 1 and 3 can stay connected thru the oe harness, and I'll just have to cut and run spark c to white/#4 wire, and spark d to the yellow/#2 wire that go to the igniter, and set the ignition setting to COP? Is that all?
The PNP harness connected to the oe harness:
Thanks!
Spark B to Cylinder 3, brown
Spark C to Cylinder 4, white
Spark D to Cylinder 2, yellow
Right now I have the ms3 running wasted spark with my fab9 COP PNP setup. It looks like cylinders 1 and 3 can stay connected thru the oe harness, and I'll just have to cut and run spark c to white/#4 wire, and spark d to the yellow/#2 wire that go to the igniter, and set the ignition setting to COP? Is that all?
The PNP harness connected to the oe harness:
Thanks!
#2
SADFab Destructive Testing Engineer
iTrader: (5)
Join Date: Apr 2014
Location: Beaverton, USA
Posts: 18,642
Total Cats: 1,866
Sounds right. When you take apart the OEM harness it is pretty obvious how they are connected. Just make sure you cut the connection to cylinders 2 and 4 after they split off from the main harness. If that makes sense.
#3
Junior Member
Thread Starter
Join Date: Jan 2014
Location: Port Saint Lucie,FL
Posts: 476
Total Cats: 12
The oem harness (4 wire connector side) plugs in to the fab9 pnp harness. I have to cut off cyl 2 and 4 from the fab harness. The oem side of the harness shouldn't need to be tampered with since I'm not using the section that splits to the 2 coil connectors.
Last edited by Mech5700; 01-14-2015 at 04:51 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM
Mikel
MEGAsquirt
4
09-28-2015 04:46 PM