Am I missing something totally obvious?!?!
#1
Junior Member
Thread Starter
Join Date: Dec 2007
Location: San Diego to LA, CA
Posts: 297
Total Cats: 0
Am I missing something totally obvious?!?!
Hey Guys,
I have a MS V3 board that is wired up for standalone on a 1.6 NA.
When I run the download.bat to upload the firmware with my easytherm settings and connect MS up to my computer running MSe and the stimulator I get all the signals to work fine.
My problem is when I load the pnp msq file I get no tach reading. What is going on here? Is this something with the stim and it will work when I install it? I have the MS modded for IAC and followed the miata pullups. I am so confused can someone please help.
Thanks
-Adam
I have a MS V3 board that is wired up for standalone on a 1.6 NA.
When I run the download.bat to upload the firmware with my easytherm settings and connect MS up to my computer running MSe and the stimulator I get all the signals to work fine.
My problem is when I load the pnp msq file I get no tach reading. What is going on here? Is this something with the stim and it will work when I install it? I have the MS modded for IAC and followed the miata pullups. I am so confused can someone please help.
Thanks
-Adam
#3
Junior Member
Thread Starter
Join Date: Dec 2007
Location: San Diego to LA, CA
Posts: 297
Total Cats: 0
Thanks a ton, that is something I wanted to hear. I was worried to put it in the car because I worried sensors were messed up. I am going to install it later next week once I finish finals. Thanks for the help.
Thread
Thread Starter
Forum
Replies
Last Post
Mikel
MEGAsquirt
4
09-28-2015 04:46 PM
Greasyman
General Miata Chat
2
09-28-2015 10:44 AM