Cross

iTrader: (4)

Ok I want to make sure I am right but my understanding of this install is something I want to check.

I am using an AbeFM unit and I have the car running but with NO IAT Input up until now.

I have run the wire for it and bought the DIY kit for the GM IAT. I am ready to go with it but since AbeFM's unit requires you to run a wire directly to the unit I am not using the factory setup obviously.

I believe that the Black with Red Stripe is the wire I still want to use and the other pin that would have gone to the pink wire in my stock harness instead goes to the New Wire run to the AbeFM unit.

Anyone care to confirm or correct me on this?

My Stock unit has a Black with Red Stripe and a Pink ire for the IAT from the Miata stock.



Car Again is a 2000 Miata NA.
AbeFM MS2 PNP Unit.
Tuner Studio Paid Version.

Thanks!



----Update----
Went with my hunch numbers seem right on.