Y axis in kPa rather then %?
The Y-axis of tables (fuel, ign, afr etc) are all in % (of what, 250kpa?).
It seems more logical to have these directly in kPa, how would I do that? |
Am I right that % equals kPa? So if I enter 180%, this would be 180kPa?
|
If you have set your control algorithm to "speed density" which you will and should have - the % are the kpa.
|
I haven't played much with my MS2 lately, but IIRC % = "Percent Baro", not absolute pressure (ie kPa). There is a setting somewhere to switch to absolute MAP pressure instead of percent baro.
Jim |
|
thx, I'm using speed density, so it's kPa. I'll have to change my tables from 100% to 200% :)
|
Try using the MSPNP maps for fuel and spark - shuold give you a good starting point.
|
All times are GMT -4. The time now is 11:26 PM. |
© 2024 MH Sub I, LLC dba Internet Brands