1.8 Supercharger Kit - 360+rwhp
#1
1.8 Supercharger Kit - 360+rwhp
I'm selling the supercharger setup from my SSM car. The SC kit plus a mild motor build made 360rwhp on E85 and 316rwhp on 91 octane, with a lot more room on top of that for more power (I was traction limited for autocross so I didn't want to turn it up more). All parts were put on the car when I built it in the spring of 2012, and were used ONLY for autocross in the period since then, with extremely limited street miles (driving to/from the alignment shop, essentially.)
Supercharger Kit: Asking 2500$
* Intake manifold custom cast and built by Corky Bell
* Lysholm 1600AX supercharger
* Custom automatic tensioner and bracket
* Custom throttle body adapter
* 75mm Mustang-flanged Throttle Body modified with the stock Miata throttle cable receiver, includes TPS and wiring pigtail
* Mustang Idle Air Controller and wiring pigtail
* Custom manifold support brace (supports the manifold+SC with the block so the intake studs don't take the load)
* GM IAT sensor pre-installed including wiring pigtail
* Intake pulls air from the area by the driver's passenger headlight
* Pics available here: Index of /pics/miata/partout/superchargerkit
Supercharger Kit: Asking 2500$
* Intake manifold custom cast and built by Corky Bell
* Lysholm 1600AX supercharger
* Custom automatic tensioner and bracket
* Custom throttle body adapter
* 75mm Mustang-flanged Throttle Body modified with the stock Miata throttle cable receiver, includes TPS and wiring pigtail
* Mustang Idle Air Controller and wiring pigtail
* Custom manifold support brace (supports the manifold+SC with the block so the intake studs don't take the load)
* GM IAT sensor pre-installed including wiring pigtail
* Intake pulls air from the area by the driver's passenger headlight
* Pics available here: Index of /pics/miata/partout/superchargerkit
Thread
Thread Starter
Forum
Replies
Last Post
JesseTheNoob
DIY Turbo Discussion
15
09-30-2015 02:44 PM