Autocross car partout + misc spares
 

Exterior
Axis Power Racing CF Hood + custom mounts + 4 locking pins $800.00 8.0 lb with lexan headlight covers and Aeroquip lockable latches on all 4 corners, Pics Available
Custom Splitter $200.00 Extends 5 inches in front of stock NA bumper cover, Pics Available
NA Whole Door $200.00 L/R available, Painted Sunburst Yellow, Includes manual windows + crank + door panel
NA Wiper Arm $15.00 Have 2
NA Rear Corner Lights (pair) $10.00 Have 2 pairs
NA Right Tail Light, complete $50.00 Have 2
NA Right Tail Light panel, no bulbs $30.00
NA Left Tail Light, complete $50.00
NA Front Corner Lights (pair) $50.00

Wheels/Tires
Set of 275/35/15 Hoosier A6s, 20 runs $500.00 Pics Available
Set of 275/35/15 Goodyear Eagle RS AX, 60 runs $125.00 2 sets available, Pics Available

Suspension off SSM Car
NB Front UCAs + V8Roadster Ball Joints (pair) $300.00 Ball joints welded into control arms, Pics available
NB Front LCAs + Delrin Bushings + Ball Joints (pair) $300.00 Delrin bushings pre-installed and properly sized/lubed
NB Rear LCAs + Delrin Bushings (pair) $300.00 Delrin bushings pre-installed and properly sized/lubed
EPMiata Rear UCAs (pair) $200.00
Front NA Uprights with Blueprinted Hubs w/ABS installed w/long studs (pair) $300.00 Hubs used for only 3 events
Rear NA Uprights with fresh bearings/hubs w/long studs (pair) $300.00 Bearings used for only 3 events
NB Power Steering Pump/Reservoir/Lines $50.00
Stock 1.6 Rear Swaybar + bushings + brackets + locators $25.00 Pics Available

Spare Suspension Parts
Front Right NA Upright, w/ABS hole, w/ABS Hub installed $50.00
Front Left NB Upright, no ABS hole, w/non-ABS Hub installed $50.00
Front Left NB Lower Control Arm w/ball joint $60.00
Rear Upper Control Arm $25.00
Front Upper Control Arm, no ball joint $25.00
Rear Right Lower Control Arm $25.00

Brakes
Stock NA6 and NA8 Front Rotor Pairs $20.00 Lightly used
NA Master Cylinder $50.00 Brand New In Box, Dorman branded

Motor/SC
Lysholm 1600AX Supercharger w/Snout/Pulley, BEGi Manifold, AutoTensioner, SC Throttle Body Adapter + Mustang 75mm Throttle Body + IAC, Custom intake setup $2,500.00 Pics Available
1.8 AWR Engine Mounts $150.00 Used, 95 duro (stiffest)
NB Knock Sensor $40.00 Have 2
Saturn Knock Sensor + Mazda Adapter $40.00
NA Oil Pressure Sensor $20.00
Clutch Slave + SS Clutch Line $40.00 Slave was brand new 3 years ago, still seals and acts like new, Pics Available
94-97 Alternator $60.00 Used but rebuilt with HQ bearings in 2012, Pics Available

Intake/Exhaust
Custom 3" Exhaust w/Bolton extra resonator for <90db Sites $800.00
Autronic Air Temp Sensor $20.00 Have 2

Ignition/Fuel
1 ebay 1ZZ Coil $25.00
FM Big Flex Fuel Kit for 90-93 with NB head $750.00 Pics Available
Injector Dynamics 1000cc Injectors w/PnP adapters $400.00 Pics Available
1.6 Stock Fuel Pump $30.00
Supra 440cc Injector (23250-42010) + Pigtail $10.00 Have 6 -- Set for 40$

Drivetrain
Spec Stage 3+ Clutch Kit $325.00 Pics Available
Stock 1.8 Motor Brackets + Mazdacomp Race Rubber Mounts $100.00 Very lightly used before switching to the AWR mounts
1.8 ABS Axle (1 piece non-flange-type) $80.00 2 available, Pics Available
1.6 Speedo Cable $25.00

Electronics
Hydra Nemesis 2.7 + Wiring from FM $1,400.00 Supports Flex Fuel
AIM Evo4/MyChron3 Dash + Water Temp Sensor $1,000.00
EVO2 12 cell battery (1.8 lbs) $90.00 Used
Custom battery holder for EVO2 16/12 cell batteries $40.00 Pics Available
1991 Stock ECU $150.00

Interior
Momo Steering Wheel Spacer 2" $35.00 Used, looks new, Pics Available
Lap Belts x2 + Bolts/Washers/Spacers $30.00 Used, super light, looks new
IOPort CM1-2 Camera Mount $50.00 Pics Available
1.6 Clock Spring $10.00 Have 2
Front Hard/Softtop Strikers (pair) $15.00 Have 2 pairs
1.6 Instrument Cluster $30.00
1.6 Combination Switch $60.00 Goes behind the steering wheel

Interested in the splitter (pics?) and a driver's side wiper arm if it's not rusted out on the spoiler bit.

I'm really surprised that no one has jumped on that s/c set up yet. I drool over that thing, I just don't have the funds at the moment. Financing available? kidding/not kidding. :drool:

how are the AWR 95 duro?

I know they say track only use but i have 88 duro motor mounts in my DD wrx and they dont bother me a bit.

Splitter pics: Index of /pics/miata/partout/splitter
I'll have to check on the wiper arm tonight.

I'm surprised no one's on the SC kit too. Prolly a dozen people that came really close to pulling the trigger, but no one has paid yet... =/ Financing available, but I don't ship until it's fully paid for. :)

They were pretty damn stiff. I have a fairly high tolerance for engine vibration and I don't know if I'd want them in my DD. Really just depends on your tolerance. I drove the 190 miles to and from Portland in one day to do some tuning on them, and life went on -- I didn't have a sore butt or anything.

Wiper arm pic: http://www.akilla.net/pics/miata/par...s/IMG_3524.JPG

Can I get pics of
-Rear NA Uprights with fresh bearings/hubs w/long studs (pair) $300.00 Bearings used for only 3 events
Thanks

Pics here: Index of /pics/miata/partout/rearuprights

Ok, you responded so fast with pm and your thread, thanks.
So this will bolt right onto my 95?

The rear uprights will bolt right in, yes.

Have you got any photos of the splitter please?

I'll take the new master cylinder and the speedo cable.

Pm coming atcha

Splitter pics: Index of /pics/miata/partout/splitter

Do a package deal on all the control arms+uprights?

We can talk, except that the rear uprights just sold on Friday. PM me if interested anyway.