94 Partout and random intercooler piping/couplers/clamps... garage cleanout!
11-02-2012, 02:19 PM
#1
Junior Member
Thread Starter
iTrader: (4)
Join Date: Dec 2007
Location: Nooga, TN
Posts: 113
Total Cats: 0
94 Partout and random intercooler piping/couplers/clamps... garage cleanout!
My turbo 94 got turned into a pancake about a year ago, and it's time to start clearing out the garage. If you think my prices are too high, offer less 
I can post photos for anything you're interested in. All parts have ~220k unless otherwise specified. All the turbo stuff (outside of IC piping) already sold. If there's something not in any list, please ask.
I was hit *hard*... the tranny tunnel was bent, a diff carrier arm snapped, and a couple control arms were bent. Everything worth saving has been pulled, and the carcass is gone.
I'm in Boiling Spring Lakes, NC: 40 minutes from Wilmington, 1.5hrs from Myrtle Beach, 2.5 from Raleigh, 4 from Charlotte.
Big stuff (i.e. no shipping):
Stuff I can ship (shipping not included):
Stuff I haven't priced yet:
Stuff that's sold/trashed:
Intercooler piping and parts:
2.0"
2.25"
2.5"
I can post photos for anything you're interested in. All parts have ~220k unless otherwise specified. All the turbo stuff (outside of IC piping) already sold. If there's something not in any list, please ask. I was hit *hard*... the tranny tunnel was bent, a diff carrier arm snapped, and a couple control arms were bent. Everything worth saving has been pulled, and the carcass is gone.
I'm in Boiling Spring Lakes, NC: 40 minutes from Wilmington, 1.5hrs from Myrtle Beach, 2.5 from Raleigh, 4 from Charlotte.
Big stuff (i.e. no shipping):
- Engine cradle $20
- rear subframe $20
- PPF with broken diff case attached $50
- Open diff $50
- 5-speed transmission $175
- Stock-ish exhaust with <10k miles $60
- Red trunk lid with slight bend on one side and scratches $15
- Driveshaft $60
- 4 solid Napa rotors w/ 15k $25
- Radiator $25
- Non-OEM shocks (unknown mileage) $20 for the set
Stuff I can ship (shipping not included):
- Clutch $20
- Flywheel $20
- 1.8L brake brackets coated with POR-15 $25/each
- Bare throttle body $25
- Steering Wheel $15
Stuff I haven't priced yet:
- Engine wiring harness
- Rear brake calipers (probably only good for cores)
- Front brake calipers (new seals)
- Hubs
- Control arms with Energy Suspension bushings coated with POR-15
- Manual steering rack (all tie rods have ~15k)
- Gauge hood (one snapped clip I think)
- Airbox with hole for AIT
- Exhaust manifold
- Airbags
- Airbag computer (probably dead--airbag light was on)
- Axles and axle stubs
- Speedometer cable
- Throttle cable
- Parking brake cables
- Mazda comp motor mounts (15k)
- Shifter, no ****
Stuff that's sold/trashed:
- Lenses/lights
- Rest of the body
- Seats
- Top
- Dash
- Remainder of interior
- Cat/exhaust
- Bare intake manifold
Intercooler piping and parts:
2.0"
- 90 pipe with lips $15
- short end with one lip $2
- 90 silicone coupler (used) $10
- Straight silicone coupler (used, black) $5
- 2.25 -> 2.0 reducer blue $8
- T-bolt clamps $2/each
2.25"
- 90 pipe with lips (2 equal length, one short/long) $15
- Straight silicone coupler (used red, new blue) $5
- T-bolt clamps $2/each
2.5"
- Rubber couplers $2/each
- Worm gear clamps $1/each
- Short straight pipes cut (no lips) $5/each
- Bends (no lips, looks like 1 90 deg, 2 60deg and 2 75 deg) $10/each
Last edited by delturcious; 11-11-2012 at 01:52 PM.
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
