Bunch of NB stuff - mspnp2, begi intake mani, injectors
 

Sold off my '99 so here I am with all the turbo goodies:

MSPNP2

It was in the car a bit over a year. Not modded at all. I'll also send you my tunerstudio registration. $620 shipped (Sold)


https://www.miataturbo.net/attachmen...ine=1442784446


https://www.miataturbo.net/attachmen...ine=1442784446



Begi intake manifold setup ( Mazda Miata Intake Manifold 1999-2005 )

Includes ford 4.6 throttle body (65mm), tps, shortened throttle cable, bracket to remote mount the stock iac (its realllly basic but it gets the job done). TB was drilled/tapped for a pre-TB wastegate line. All you need is a tps pigtail, and ideally some forced induction. :) $650 shipped

https://www.miataturbo.net/attachmen...ine=1442784446


https://www.miataturbo.net/attachmen...ine=1442784446


https://www.miataturbo.net/attachmen...ine=1442784446

A couple Bosch EV14 injector sets

One set is 850cc, direct fit for a miata. Used them about a month - I was a little overzealous and got these when I still had an MS1. Figured out I was better off with a more reasonable sized injector. $100 shipped (Sold)

Second set is 550cc. Need adapters for the harness (included) and spacers on the fuel rail (not included). These were on the car ~2.5 years. $80 shipped (Sold)


https://www.miataturbo.net/attachmen...ine=1442784446



https://www.miataturbo.net/attachmen...ine=1442784446


Also, I'm located in northwest CT if there's any local interest in anything.

I'll take the 850cc injectors. Pm'd you.

If deal falls through I'll take the injectors

Does the Megasquirt come with anything else?

The serial cable, a tunerstudio reg. and the connector for the accessory port (never used).

Do the PNP units use the stock harness? My only experience is a rev built unit that came with a harness. Or does this unit not come with an included harness?

Yea, the stock harness plugs right into this one. There's also stock tunes available off the mspnp site to get it running initially.

Bump

Bump

One last bump

Does this manifold actually help with anything? Do they have any Dyno numbers comparing it to stock or squaretop?

Top end certainly felt a lot better, but I don't have before/after numbers for it on mine.

Begi claims between 20-30whp increase with the stipulation that it be above 270whp already and running >14psi.

.

Anyone have the part number for the filter for this? I don't know how to search for it. I tried multiple times. This thread is large. Help a brother out. Thanks.

EDIT - I lost the stupid filter again and now I am taking a road trip. I have screen filter over the 3d pipe but I can't have that for a road trip going down the Tail of the Dragon. It's a long trip from my home.

What thread do you think you are in? Maybe that's why you can't find anything.

@IB Nolan, how many utags in threads that were needlessly bumped due to the new "scrolling" feature will it take for your team to remove it from the site?