Greddy/Turbo Tony setup for 1.6 Miata
10-20-2014, 08:06 PM
#1
Elite Member
Thread Starter
iTrader: (8)
Join Date: Jun 2008
Location: WNC
Posts: 1,648
Total Cats: 55
Greddy/Turbo Tony setup for 1.6 Miata
Just pulled this off my car to swap out for a different combo. Has been totally reliable for the almost 2yrs I've used it, and also for the previous owner who had it for a few years before me.
No thrust play at all, minimal axial play, no compressor wheel contact with the housing as shown in the close-up. Does not burn oil.
Greddy cast manifold, no cracks, relief cuts already made on the flange. Greddy/Mitsu TD04 turbo, includes the oil feed banjo fitting and modified oil drain tube (so it clears the inner fender shelf). Turbo Tony 2.5” 1-piece downpipe. I have a brand new 40” braided steel oil feed line I can let go of, too.
Doesn't look pretty but gets the job done. I just ran it at the local 1/4mi strip last month and went 13.5@110 so there's plenty of power to be made with it (I was making about 240whp based on my time/trap). And that's at 5000' above sea level. So for all you guys who aren't as high as we are in CO
you can do even better
Not going to separate the mani/turbo/dp unless I get buyers for everything.
Prices are shipped/insured CONUS. You pay the 3% to Paypal unless local and cash.
Manifold/turbo/downpipe combo $750
Oil feed line $30
No thrust play at all, minimal axial play, no compressor wheel contact with the housing as shown in the close-up. Does not burn oil.
Greddy cast manifold, no cracks, relief cuts already made on the flange. Greddy/Mitsu TD04 turbo, includes the oil feed banjo fitting and modified oil drain tube (so it clears the inner fender shelf). Turbo Tony 2.5” 1-piece downpipe. I have a brand new 40” braided steel oil feed line I can let go of, too.
Doesn't look pretty but gets the job done. I just ran it at the local 1/4mi strip last month and went 13.5@110 so there's plenty of power to be made with it (I was making about 240whp based on my time/trap). And that's at 5000' above sea level. So for all you guys who aren't as high as we are in CO
you can do even betterNot going to separate the mani/turbo/dp unless I get buyers for everything.
Prices are shipped/insured CONUS. You pay the 3% to Paypal unless local and cash.
Manifold/turbo/downpipe combo $750
Oil feed line $30
0
10-23-2014, 02:02 AM
#2
Senior Member
Join Date: Jul 2014
Location: Milwaukee, WI
Posts: 1,133
Total Cats: 551
i have a T25 sitting on my desk waiting to be installed with the appropriate manifold/dp setup......
but this is tempting me.. decisons on TD04 vs T25 are now occurring...
but this is tempting me.. decisons on TD04 vs T25 are now occurring...
0
11-04-2014, 05:37 PM
#6
Newb
Join Date: Jun 2012
Location: Huntington Beach California
Posts: 14
Total Cats: -4
Good deal I would buy it, but I already have one. Very reliable setup. Beats egay all day.
0
Thread
Thread Starter
Forum
Replies
Last Post
