1.8 part out (MSPNP, 550s, new ssm kit, tein, kosei)
09-19-2009, 05:35 AM
#1
Senior Member
Thread Starter
iTrader: (2)
Join Date: May 2007
Location: Malibu, CA
Posts: 749
Total Cats: 0
1.8 part out (MSPNP, 550s, new ssm kit, tein, kosei)
Seriously considering parting out the car, lots of the parts have not even been installed. Parts located in Malibu/Irvine (socal).
NEW! Begi SSM kit
Parts were test fitted on the car but the car was never started, everything came off and was wrapped back up
-options-
GT2860R turbo
Begi intercooler piping (with big ebay IC)
Seperated gasses downpipe
Wideband O2 bung
Turbo and manifold heat shields
Stainless coolant lines
- The kit is still new, and has just a scratch or two on the DP from test fitting it, and a couple of studs already threaded in, cost over $3400 new, I'll even throw in some oil filters and 1 step colder spark plugs.
$2,800
Tein SS coilovers with NB tophats fully assembled.
~15k miles
$750 Sale pending
Kosei K1 15x7" with 225/45/15 Hankook RS2 ~25% tread
$350
Koyo 37mm radiator
No leaks, had a small puncture at one point and was professionally repaired. Kept my car icy cold at my last track day (rad has only been in one).
$180
FM front anti-sway bar and bushings.
$75 Sale pending
Megasquirt PNP 96-97
Comes with serial cable and iat sensor, car ran great on it.
Sold
Hard Dog Sport Dual Diagonal Roll Bar
Sold
Hard Dog Bolt in Harness Bar
Sold
ISC short solid endlinks (prevents larger sway bars from hitting the control arms on lowered cars)
Sold
More parts will go up over the next couple of days along with pics. Coils, wheels, sways, endlinks, roll bar, and harness bar are all still on the car.
Prices are obo, but please no lowballers.
NEW! Begi SSM kit
Parts were test fitted on the car but the car was never started, everything came off and was wrapped back up
-options-
GT2860R turbo
Begi intercooler piping (with big ebay IC)
Seperated gasses downpipe
Wideband O2 bung
Turbo and manifold heat shields
Stainless coolant lines
- The kit is still new, and has just a scratch or two on the DP from test fitting it, and a couple of studs already threaded in, cost over $3400 new, I'll even throw in some oil filters and 1 step colder spark plugs.
$2,800
Tein SS coilovers with NB tophats fully assembled.
~15k miles
$750 Sale pending
Kosei K1 15x7" with 225/45/15 Hankook RS2 ~25% tread
$350
Koyo 37mm radiator
No leaks, had a small puncture at one point and was professionally repaired. Kept my car icy cold at my last track day (rad has only been in one).
$180
FM front anti-sway bar and bushings.
$75 Sale pending
Megasquirt PNP 96-97
Comes with serial cable and iat sensor, car ran great on it.
Sold
Hard Dog Sport Dual Diagonal Roll Bar
Sold
Hard Dog Bolt in Harness Bar
Sold
ISC short solid endlinks (prevents larger sway bars from hitting the control arms on lowered cars)
Sold
More parts will go up over the next couple of days along with pics. Coils, wheels, sways, endlinks, roll bar, and harness bar are all still on the car.
Prices are obo, but please no lowballers.
Last edited by speedf50; 10-03-2009 at 07:33 PM.
Reply
0
0
09-19-2009, 02:40 PM
#8
Too bad I didn't see this before I sent your shocks out this morning - I would of held up sending them out. I just bought a set of used Tein SS's and they seem almost as compliant as the Bilsteins but a lot more fun around corners. PM me if you want to send them back.
Reply
0
0
09-20-2009, 07:33 AM
#10
Even if I hadn't bought it I still couldn't swing this right now...but if next paycheck is big enough Teins sure would rock.
Your Bilsteins were the only way within my budget to get back to DD civility. CHEAP, FIRM, COMPLIANT....pick two. I'll have to sacrifice firmness for now. Besides...I just got the line on some MSM springs that should make it a very nice setup short of Teins or FCM stuff.
Thanks for getting it shipped out quickly.
Good luck with sale OP...will let you know if I hit a windfall. That's a great price on a great setup...sad to see you parting out though.
Reply
0
0
09-20-2009, 08:11 PM
#12
Senior Member
Thread Starter
iTrader: (2)
Join Date: May 2007
Location: Malibu, CA
Posts: 749
Total Cats: 0
Sorry for the late responses, I'm moving this week and won't be back home where the parts are until the weekend. Once I get back I'll wrap everything up, take pics, and try to ship out some items.
BTW I need a power steering or manual rack, trades?
BTW I need a power steering or manual rack, trades?
Reply
0
0
09-21-2009, 01:46 PM
#17
Senior Member
Thread Starter
iTrader: (2)
Join Date: May 2007
Location: Malibu, CA
Posts: 749
Total Cats: 0
Sale pending on the injectors.
All I have right now is a pic of the wheels on my car. I'll try to snap some closeups when I get back home.
Original post edited, FM sways and ISC endlinks added.
All I have right now is a pic of the wheels on my car. I'll try to snap some closeups when I get back home.
Original post edited, FM sways and ISC endlinks added.
Reply
0
0
